Fast Setup: Configure Your D-Link WBR-1310 Router Quickly

D-Link WBR-1310 Quick Router Setup — Step-by-Step Instructions

Follow these concise steps to get your D-Link WBR-1310 online and secure in under 15 minutes.

What you’ll need

• D-Link WBR-1310 router, power adapter, Ethernet cable
• Active modem (cable/DSL) and its Ethernet cable
• A laptop or PC (preferably wired to the router during setup)

1. Physical connections

1. Power off your modem.
2. Connect the modem’s Ethernet cable to the router’s WAN/Internet port.
3. Connect your computer to any LAN port on the router with an Ethernet cable (recommended).
4. Power on the modem, wait until it’s fully up, then power on the router.
5. Verify router LEDs: Power, WAN, and the LAN port in use should light.

2. Access the router web interface

1. Open a browser on the connected PC and go to: http://192.168.0.1 or http://dlinkrouter.local
2. At the login prompt enter the default credentials:
   • Username: admin
   • Password: (leave blank)
     If these don’t work, perform a factory reset (press and hold Reset ~10–15s) and try again.

3. Run the Setup Wizard (recommended)

1. After login, click the Setup Wizard or Setup → Launch Internet Connection Setup Wizard.
2. Create a new router admin password when prompted — choose a strong password and save it.
3. Select your time zone and click Next.
4. Choose your Internet connection type (common options):
   • Dynamic IP (Cable) — usually “Automatic/DHCP”
   • PPPoE (DSL) — enter ISP username and password
   • Static IP — enter values provided by ISP
5. Enter DNS settings if your ISP provided them (otherwise leave automatic).
6. Click Connect/Save. Wait for the router to apply settings and reboot if needed.

4. Configure Wi‑Fi (wireless network)

1. Go to Setup → Wireless Settings (or Wireless > Primary